1975 Dufour 27 Refit | Wednesday, November 12, 2008

The pinhole filler had cured overnight, so I sanded the areas needed, and then hand-sanded a few detail areas:  the cove stripe recess and around a few fittings as required.

Afterwards, I vacuumed, solvent-washed, blew down, and otherwise cleaned up the shop and boat, washed down the floor and staging, and then performed the final solvent wash and tack-off.  Finally, I applied three coats of gray finish primer to the hull.



Total Billable Time on This Job Today:  5.75  hours

<Previous | Next>